Oil life indicators are real-life saviors as they save you from changing oil too soon or too late. Read further on n how to reset the oil life on a jeep wrangler.
A timeous oil change is important as it not only extends your vehicle’s life by protecting its internal parts but also enables you to drive smoothly in harsh conditions. Considering the importance of timeous oil changes, Jeep Wrangler has introduced the feature of oil life indicators on their automobiles.
FAQs
Many drivers don’t take the warning seriously but you should! When an oil light is turned on, it shows that your vehicle has a below-average oil level. If you keep driving your vehicle with low fluid, the internal parts may be subject to grinding which in turn lowers their service life. Is oil life reset accurate? In most vehicles, oil life resets are pretty accurate as these systems have been tested and proven various times in the past. Why is my oil light still on after the oil change? Your oil light indicator may show an oil change message even after the oil change due to faulty sensors. Dirt, debris, and other contaminants may make their way into the oil tank which in turn may cause the sensors to identify false issues. This indicator will let you know when your Jeep needs an oil change. This oil life system works by keeping a track of engine mileage and time since the oil has been in use. Generally, this oil indicator light gets on every 3000 miles. So when your Jeep shows an oil change indication, you need to change engine oil immediately and reset the oil life to 100% by turning off the light manually. Although resetting the oil life doesn’t leave any impact on the drive quality, it is still considered necessary as it saves you from changing the oil too late or too soon. So without any further ado, let’s have a quick look at how to reset the oil life on the jeep wrangler guide. Follow the given steps to reset the oil life to 100% in your Jeep Wrangler models made in the year 2007-2017: Step 1: Put your car’s key into the ignition and turn it smoothly to the accessory mode without running the engine. Step 2: Wait for a few seconds until the lights go off. Step 3: Once done, press the gas pedal thrice within ten seconds. Remember that you need to push this pedal all the way down. In some jeep models, a ding sound is released, indicating the oil life reset. However, this feature is not available for all jeep models so you should move to the vehicle info section to confirm the oil life reset. Step 4 : The final step is to navigate to the section of vehicle info. From there, select the oil life. On this, the current oil life will be displayed. If a reset is done successfully, the system should show 100% oil life. Below are the steps you need to follow to change your Jeep Wrangler 2018-2022 oil life to 100% and remove the oil change message from the dashboard. Step 1: Turn the key into ignition and then turn it into the run position. If your Jeep has a push-to-start feature, push the corresponding button two times to set it on the run position. Step 2: After setting your Jeep on the run position, you need to press the buttons, located on the left side of the steering wheel. Keep scrolling down the tab using these buttons until you find an option for tire pressure/vehicle info on the display. Step 3: On finding the menu to vehicle info, keep pressing the over button on the left or right until you are navigated to the oil life tab. Step 4: On reaching the oil life menu, press the okay button and hold it until the bar hits 100%.
Leave a Reply